freshly installed XI server? how to proceed

[Former Member]

i have got a freshly installed XI server,

can u tell me how to proceed maintaining TS and BS in SLD,

[Former Member · Accepted solution]

Dhar,

I hope you have done the Post installation steps. Also do a SLDCAHCE. It shows whether there are any errors in connecting to SLD. If everything is OK then try to develop this sceario where he has also mentioned how to create TS and BS in SLD.

/people/srinivas.vanamala2/blog/2007/02/05/step-by-step-guide-xml-file-2-xml-file-scenario-part-i

/people/srinivas.vanamala2/blog/2007/02/05/step-by-step-guide-xml-file-2-xml-file-scenario-part-ii

Regards,

---Satish

[Former Member · Accepted solution]

SATISH,

the i think the post implementation has also not been done, there is no TS maintained in the SLD ...not the XI system.....

[Former Member · Accepted solution]

hi sudeep,

first run all the post installation configuration templates. then you will get a technical entry.

procedure to run the Post installation templates.

go to this http link

http://<xihostname>:50000/index.html

then go to SAP NetWeaver Administration

Deploy and change and run the templates for NWD,SLD and PI templates.

After post installation, import the XI BASIS Content to the design environment.

Regards,

Ramesh P

Regards,

Ramesh P

[Former Member]

Hi,

post configuration steps from post installtion/configuration guides

http://help.sap.com/bp_bpmv130/html/Specific_Info.htm

regards,

vasanth.

[Former Member]

Hi,

plz refer the following:

Why SLD config? pre-requisites ?

for documentation visit this link

http://help.sap.com/saphelp_nw04/helpdata/en/e7/01503ede925441e10000000a114084/frameset.htm

/people/sugree.phatanapherom/blog/2005/08/14/configuring-sld-in-sneak-preview-sap-netweaver-04-sneak

regards

Message was edited by:

Vijaya Lakshmi MV