cancel
Showing results for 
Search instead for 
Did you mean: 

CCUNDO T_CODE

Former Member
0 Kudos

DEAR GURUS,

HOW TO MAKE USE OF THIS T_CODE (CCUNDO). I AM NOT ABLE TO MAKE OUT WHAT THIS DOES. I HAVE TRIED CREATING CHANGE NOS. THEN CHANGING THE ATTACHED OBJECTS USING THE CHANGE NO.

LATER I TRIED TO UNDO THE CHANGES USING THIS T_CODE.. BUT IT ALWAYS GIVES THE MSG. "No changes found for change number ".

I AM USING ECC6.0.. THIS T_CODE WAS NOT AVAILABLE IN 4.6C

CAN ANYONE HELP?

Accepted Solutions (1)

Accepted Solutions (1)

daniel_huber
Employee
Employee
0 Kudos

Hi Abhishek,

this undo functionality works for the following objects:

- Bill of material

- material master (planned changes only)

- Variant configuration objects (object dependencies, configuration profile, variant table)

There is a BADI ECM_UNDO to extend support for additional (customer) objects or enhance the standard behaviour.

Please reward points if answer is helpful.

Best regards, Daniel

Answers (1)

Answers (1)

rpaluri
Explorer
0 Kudos

Daniel

I was looking up on CCUNDO and not able to find a way to activate it. I could only find this thread on Google search.

When you mention "Material Master - Planned changes only" what does it mean? How is a change planned to the material master, by what means/transaction? does this mean that we can not use this transaction CCUNDO to reverse a change done through MM01, with ref to an ECN?

Please let me know if you know what purpose it works. Thanks a lot for your help.

-Ram

+1 (972) 999 0420