XSL Map refresh does not work

[former_member184385]

Hi all,

my scenario

1. receives a DEBMAS IDOC from SAP (IDOC adapter)

2. maps it by an XSL amp

3. sends it to a 3rd party (3rd party adapter)

I had an error in the XSL map. So i

a) fixed the error, uploaded the map to the Rep. Builder and refreshed the Engine cache.

b) then i resend the errornous message in RWB a couple of times to no avail

But: the changed map takes no effect, i still get the "old" errornous message out from the mapping.

Any ideas?

Thanks, Gregor

[agasthuri_doss]

Hi,

Check whether your new Message Mapping is activated and try to delete the Meta data in Idx2 and try

Regards

Agasthuri Doss

[Former Member]

1) Delete old XSL from IR

2) Ensure interface mapping references the new XSLT

3) Test your interface mapping in IR

4) Refresh cache (via http://...cpacache url)

5) In ID delete interface determination and reconfigure with new mapping

6) ABAP cache refresh via SXI_CACHE

check cache notifications in SXI_CACHE and cache log in ID.

this should solve it... especially steps 2 & 3

sincerely,

--NM

[Former Member]

Naomi,

I think the problem is you are resending the failed message only. Rather than that I would suggest you to send a new message and see. If you activated both the message and interface mapping it will take the new mapping only.

Regards,

---Satish

[Former Member]

> Naomi,

>

> I think the problem is you are resending the failed

> message only. Rather than that I would suggest you to

> send a new message and see. If you activated both the

> message and interface mapping it will take the new

> mapping only.

>

> Regards,

> ---Satish

Satish... I think you mean the original poster not me

Sincerely,

--NM