Problems XI/PI with displaying adapters in adapter monitioring

[Former Member]

Hi everybody,

we have yet installed XI/PI 7.0 SP09. In the adpater monitoring we can only see the JPR adapter but no other standard adapters (FILE, JDBC etc) are displayed.

Furthermore the adapters could also not be selected during creating a communication channel in Integration directory.

<u>Already done:</u>

1. We have made adapter full cache refresh (CPA Cache)

mentioned following:

a) empty cache even after refresh

b) "SAI_CACHE3_REFRESH_BACKGROUND" Job not "displayed" in SM58?

2. successfully Connection tests in component-monitioring (RWB)

Only Web Service security yellow status (integration engine)

Thanks for your help.

Best regards

Mario

[former_member184619 · Accepted solution]

Hi Mario,

<i>In the adpater monitoring we can only see the JPR adapter</i>

All the adapters except for JPR will be greyed out if you are working on PI 7.0 as these options have been moved to communication channel monitoring.

Regards,

Sachin

Message was edited by:

Sachin Dhingra

[Former Member · Accepted solution]

Hi Sachin,

Thanks for answering my question so rapidly.

Your are right, the adapter monitoring was moved from Adapter Monitoring to Communication Channel Monitoring(CCM), but in the CCM we can only see the JPR Adapter in the combo box Adapter types.

Furthermore in the Adapter Monitoring the greyed out adapters are also not displayed.

So have you an answer about our difficult case.

Thanks a lot.

Regards,

Mario

[prateek · Accepted solution]

Possible Solutions:

Possible Solutions

1. Re-import SAP BASIS SWCV 7.0 into Integration repository

2. Refer SAP Note 764176.

3. /people/venugopalarao.immadisetty/blog/2007/03/15/adapter-engine-cannot-be-found-in-integration-directory

Regards,

Prateek

[Former Member]

Most likely the post config step is missing:

"Importing the XI Content for Software Component Version SAP Basis"

This is in the install guide and should be done by basis after install.

You can get the .tpz file from Service.Sap.Com

You can get the steps from the install guide or from help.sap.com - basically you need to place it in the import directory and import it from the IR.

The metadata for the adapters is in this software component for basis, this is why you cant see any from the drop-down list. JPR adapter status isnt a good indicator of all adapters being present.

hope this helps,

--NM