on 07-18-2007 3:10 PM
Hi all
I am using a dummy correlation in my bpm
I have specified the dummy correlation as an active correlation in my first receive step
The second receive steps comes immediately next to the first one
here in the "Properties" tab for the step, the "Use Correlation" property shows up with a question mark indicating that it is mandatory and if i pull down the list i dont see my dummy correlation. In fact , it is just an empty list
why is this so?
thanks for your time
regards
krishna
create another dummy correlation WRT to the MT in the second recv and check out.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Your correlation is probably not configured completely...
Your 2nd receive step - does it use a message type that is involved in the correlation (you would have defined this in your correlation editor).
Is your correlation saved?
sincerely,
--NM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.