how to send "collect idoc" idocs

[Former Member]

i have a idoc to XI scenario, in r/3 from where i trigger IDOC, i found in partner profile that the message type has attribute "collect idoc",

so once i trigger idoc, it shows status 30, how could i release them, i dont need "transfer immediately",

i just want to trigger those collected idocs

[prabhu_s2 · Accepted solution]

check with rbdmidoc

(earlier posted content deleted)

Message was edited by:

Prabhu S

[Former Member · Accepted solution]

Hi prabhu,

i tried that program, but still the collected idocs never went, and how come change pointers come in to picture in this case

[prabhu_s2 · Accepted solution]

if u wanna to send idoc for any master data then u can use this program to process idoc. change pointers are related when an field in any of the master trasncation are changed the pointer id's will be set and when upon executing this program the idoc are generated wrt the transaction. but again u need to go for a complete config for change pointers also.

[prabhu_s2]

use RSEOUT00 to process all collected idoc.

[Former Member]

T-code WE14

[Former Member]

Hi sudeep dhar

In the partner profile double click on message type and select the option a collect idoc.

Thanks

Rinku

[santhosh_kumarv]

Hi

Double click on the the message type of the r/3 system.

In the outbound option select the outbound mode as Collect IDocs

Regards

Santhosh

[prateek]

Inside partner profile (we20), double click ur message type. U have an option there to tranfer immediately or collect idocs

Regards,

Prateek