on 06-25-2007 2:35 PM
Hi all,
While i am trying to configure printer ,the spool n output requests r been created but it says 'Unable to reach the remote host spool system'.
I am unable to get where i am goin wrong.
Unable to reach the remote host spool system
Message no. PO537
Diagnosis
The SAP spool system cannot connect to the host spool system to which the requests for this output device are to be sent.
System Response
Requests sent to this output device cannot be proccessed. They remain in status Waiting.
Procedure
This message usually means that the host you specified under destination host (Host spool access method tab) is either down, or the transfer program SAPLPD (or LPD) is not running on the host.
Procedure for System Administration
Check to determine whether the destination host is on, or whether SAPLPD (or LPD) is running.
Ya it clearly says to SAPLPD isnt running....
Plz tell me how can v make SAPLPD running n how to check the same?
Plzzzzzz Help.
Thanks,
Malti
it may be a matter of the extremly bad design of SPAD gui,
that forces to maintain data with error, e.g. missing LPD-PortNo.
=> https://scn.sap.com/thread/3940963
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello
As per my Observation
'Unable to reach the remote host spool system"
Will Be Happened when Spool Server and Host Have Changed
Please do reset the Spool server and Save.
The Problem will be Solved
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Malti,
I have observed that the same way is very important verify the fisical conections because the message explain that don´t reseach the printer.
Check fisical printer is important for descart that posibility.
My answer maybe could help someone.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi malti
Please Check the access method of printer is frontend or not then check the lan connection of target. if some problem in saplpd then u have to down load saplpd program from sap portal it totally free. so stry to upgrade the saplpd program up to current release.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
25 | |
12 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.