on 06-05-2007 11:40 AM
Hi Experts,
In the RWB, when i click on Alert Configuration it shows error 404. For this i performed steps as per note 750287 in which i did all the required changes as per smicm.
But even after all these steps i am getting error while accessing alert config.
Even when i try to log on to end to end monitoring it is asking for user name and password . i have tried all with the help of basis guy.
Now what should i do to get the desired configuration done.
Regards
Saras Jain
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Saras,
404 in general means, page not found (in HTTP terms). This usually happen when application is not installed/configured properly.
Did you do the post installation steps ?
If you are prompted for username and password, I would say, that is better than 404. The application is running and it is trying to authorize you.
Which username are you using to login?
cheers
danus
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
83 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.