on 06-05-2007 9:25 AM
Hi
At present we are on R/3 46C,Oracle 8i, HP UX 11i.
Our exisiting H/W, OS and DB is being upgraded to meet the demand for future ECC upgrade. This upgrade is done by a seperate vendor.
Present:
SAP  KERNEL 4.6D 64-BIT
DB   ORACLE 8.1.7
OS   HPUX  11.11/PA-RISC
After the H/W,OS & DB upgrade, the configuration will be as below,
Future:
SAP   KERNEL 4.6D 64-BIT
DB   ORACLE 9.2 64-BIT
OS   HPUX  11.23/IA64 64BIT
After the successful upgrade, what are key checks that we have to perform from BASIS side to ensure that everything works fine before releasing the system to end users.
Pls drop your valuable thoughts on this regard.
regards,
Vinodh.
as you're performing a system copy (pa-risc -> ia64) you'll need to perform all checks mentioned in the relevant guide and the relevant sapnotes...
GreetZ, AH
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Install Kernel 4.6D_EXT
and I'd recommend upgrading to Oracle 10g instead of Oracle 9i. Extended support for 9.2 is valid until 31st of July 2008, after that you need to install 10g. ECC 6 also needs 10g.
After the upgrade check that your printers are installed and working.
--
Markus
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.