on 06-05-2007 7:23 AM
When I execute report V23, I cannot pull any data, I am ECC6. I ran the report SDSPESTA for good measure too.
But I can see the correct values in table VBUP.
Is there some configuration needed for this report to work?
Thanks in advance for all help.
-PRatibha
Hi ,
Are you using any variant's . If so you will need to check up the variant values, see what is defined and what for what values the data will be reported.
Reward points if this helps.
And also for this transaction their is no configuration to be made. Just that based on the configuartion of blocking reasons or block of order type etc this will be picked up in the report.
Thanks,
kamal
Message was edited by:
Kamalakar vp
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.