EDI: Sender partner number in control record is default

[Former Member]

Hello!

Another problem... in SUS - MM, Plan Driven Procurement

I try to send PO from MM to SUS. But in the messages I get following

error: "EDI: Sender partner number in control record is default"

Message no. EA608

SAP Note Number: 111342 doesn't help

the logical systems are maintained!

Any idea about this problem?

Kind regards,

Barbara

[Former Member]

If this is in regards to an ASN:  Check to see if this customer buys several divisions or is relevant for one division only.  In our instance of SAP, we found that it didn’t go to the Customer Master division setup relevant  to the division on the ASN to get the ACCT AT CUST field, it went to the first in the sequence of divisions and got that ACCT AT CUST field information.  That information was not filled out as it was a new division and that is what kept the output from happening.    For example:   we had divison 02, 04, 06 and 08.   We added division 03 and extended all customers to division 03.     Those customers that only bought division 04 just stopped sending ASNS.    The ASN was for division 04, but SAP logic was retrieving the ACCT AT CUST information (SALES tab, not CORRESPONDENCE tab) for divison 03, but we didn’t have that filled out. 

Hope that helps.  

[Former Member]

Dear Barbara,

Did you maintain Partner Profile and Port. Check in WE20 and WE21.

I hope you are not mapping control record in your message mapping in XI. If you are, you would need to check your mapping program in XI.

Regards,

Naveen.

[Former Member]

Hello!

We have just done the release change and copied the same time

our productive system to the testsystem. In the former test system

everything worked fine ... but now some inputs are missing.

It is no problem of the XI!

Isn't there anything in the customizing besides the T000, where the system

tries to get the information of the Sender partner number?

Thankful for every help,

thanks

[Former Member]

Hi,

In SUS-MM scenario, while sending PO from MM to SUS it has to pass through XI, please check in the SMQ1 and SMQ2 in both the system and also check SXMB_MONI in the XI system it gives u the correct error and solution.

Please award the points if it helps.

BR,

Vijay Mittal