IDOC - XI - IDOC same port name in IDX1

[laurent_touillaud]

Hello,

i have a problem in defining multiple receiver systems in IDX1.

We have to send idocs to different system and some of them have the same SID.

Receivers would have the same port name SAP(SID) ex : SAPPRD

How could xi know which is the correct receiver port?

Thanks,

Laurent.

[Former Member · Accepted solution]

Port name might be the same, but the RFC destination for each port is different. We use the the combination of port and RFC destination in communication also. Hence I guess there should not be any conflict.

I may be wrong here. Correct me if am wrong.

Regards,

Jai Shankar

[laurent_touillaud · Accepted solution]

Hi thanks for the response,

Actually you are right but i made a mistake it's on the sender port where we have the problem.

When the 2 sap systems have the same SID the incoming idoc is in error because sap doesn't know which is the correct port to take.

If you know this...

[bhavesh_kantilal]

In these cases, adding the client number helps.

<b>SAPSIDClientNumber</b>

Regards

Bhavesh