cancel
Showing results for 
Search instead for 
Did you mean: 

Configuration of Mobile Infrastructure - Error in NWA

Former Member
0 Kudos

Hi all

I have followed all the procedures to configure the Mobile Infrastructure for NW 2004s. But the Mobile Infrastructure tab in NW Admnistrator shows the following errors in maximum of the screens.

"Unable to read data. Reason: Could not connect to middleware"

and in Mobile Components tab it shows the following if I try to search for the deployed components.

Couldn't create ManagedConnection with . {jco.client.passwd=****, jco.client.lang=EN, jco.client.sysnr=01, jco.client.client=001, jco.client.user=MI_SERVICE, jco.client.type=A, jco.client.jra_conn=true}

I am not able to figure out where I went wrong. Please let me know a solution to fix this issue.

Thanks

Raj

Accepted Solutions (0)

Answers (1)

Answers (1)

satyendra_dhar
Active Participant
0 Kudos

Hi Raj,

<b>Reason and solution for the error.</b>

1. SAPJRAFactory_LANG(i e EN) settings are not correct, make them correct according to your installation type of J2ee-Engine (Cluster or Standalone).

Please set the following properties on SAPJRAFactory...

<b>For standalone Installation -:</b>

SAPClient - <Client>, for example, 000

ServerName - <Server Name>, for example, bcemain.wdf.sap.corp

<b>PortNumber</b> - <System Number>, for example. 01

Language - <Language Key>, for example, EN

UserName - <User Name>.use service user with RFC Autorizatn

Password - <User Password>

<b>For Cluster Installation-:</b>

SAPClient - <Client>, for example, 000

SystemID - <System ID>, for example, BCE

MessageServer - <Message Server>, for example, bcemain.wdf.sap.corp

Language - <Language Key>, for example, EN

UserName - <User Name>. service user with RFC authorization

Password- <UserPwd>

Here is the link to configure it-:

http://help.sap.com/saphelp_nw2004s/helpdata/en/43/1d7d843fce3566e10000000a11466f/frameset.htm

2. After doing above steps restart the engine.

Hope this helps you.

If you get the same error again then please send the property list you set in SAPJRA.

Regards,

Satyendra

Former Member
0 Kudos

Thanks Satyendra,

will get back to you after trying this.

Raj

Former Member
0 Kudos

Satyendra

The RFC destination was not working properly. I corrected it and also guess I may have messed up with the password. I went through the entire procedure slowly and now NWA is working fine.

Thanks for your help

Raj