on 05-13-2007 12:08 PM
Hi,
I have created a Z Driver Program and Smartform and assigned to Output type 'NEU' .
In general after issuing the output of the Purchase Order. Output log should be created. But when I issue the PO output and check the log the log has not been created.
Regards,
Ramu N.
Message was edited by:
Ramu Nemurgommula
If u want to update the Processing log for a particular output...
Then use NAST_PROTOCOL_UPDATE.
Thanks,
Message was edited by:
Utsah Garg
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
check NAST table , it will creates the LOG.
Regards
Prabhu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
There exists function module starting with 'INITIALIZE'. You can call this in your Z program by passing relevant messages wherever required. Thereby log will be updated.
thanks,
sksingh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.