on 09-12-2016 11:13 PM
Hello,
In one of the DC Groups' I have a DC Parameter that is of type Numeric. It has MIn value / Max Value and MASK is set as ##.#
Now when I enter any value which is out of spec and not matching the MASK, ME gives me a popup saying DC Parameter is outside min/max limits. When I press OK, it takes me back to DC Collection screen but DC parameter value which is of wrong format is greyed out and I can't correct it.
Example:
DC Group with DC Parameters. Mask is set as ##.#
Now when I enter values and press Save:
If I press OK then ME takes me back to DC Collection screen but does not allow me to correct the value which has wrong format:
Is this a bug?
Regards,
Soham
Hi Soham,
This observation really looks like a bug, though the expected behavior requires investigation of the entire setup.
Regards,
Sergiy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Soham,
This looks like a bug, as I wrote, because I do not see anywhere in the documentation that some fields of DC Group can be editable whereas others are greyed out. You should open a support ticket against MFG-ME-PRD-DC component and provide the entire scenario with full configuration.
Regards,
Sergiy
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.