Material replication issue- SRM

[Former Member]

I am trying to replicate the material from back-end ECC to SRM 7.0, did almost all the setting.

But in R3AM1, I am getting the message as attached - 

Status: Wait &

Additional Information : Parent Not OK: DNL_cust_prod1

Can somebody guide me on this, what could be the reason for this?

[vinita_kasliwal · Accepted solution]

Hi Atul

Please Check all points as below

1. Please delete queues from SMQ1 and SMQ2 on both servers SRM and ECC.

2. In R3AM1,  cancel failed object DNL_CUST_PROD1 and re run object in DNL_CUST_PROD1

3. Check Site setting (SMOEAC) both SRM and ECC are correctly defined there will be CRM instead of SRM which is fine also RFC Destinsation are working

try to remote login and check connections

4. You need to make sure that  the following objects has been replicated successfully( Green Light should appear):

DNL_CUST_BASIS3 (units of measure, dimensions, and currencies)

DNL_CUST_PROD0 (product categories)

DNL_CUST_PROD1 (product categories)

5. Check all table entries are correct;y configured CRMCONSUM,CRMRFCPAR,  CRMPAROLTP and others

Refer these links for middle ware configuration as well for a similar error which you are facing

http://scn.sap.com/community/crm/master-data-and-middleware/blog/2014/09/15/why-parent-not-ok

http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/309258e9-0da2-2d10-b598-bf27edb56...

http://scn.sap.com/people/marcin.gajewski/blog/2007/02/05/how-to-replicate-material-master-from-r3-t...

Regards

Vinita