How can I use end.Separator 'nl' in TXT file in PI/XI?

[Former Member]

Hi friends,

Look,

I have create a scenario file-to-file .TXT PI/XI, but I have problem just with file of Output, look:

This is input file, I have 3 lines

This is output file, there is only the results of line 1

Look the end.Separator 'nl', How can I use this separator in Input file? Thanks

[former_member186851 · Accepted solution]

Hello Fabiano,

Its not endseparation  ,it is endSeparator.

try with it and let us know

[manoj_khavatkopp · Accepted solution]

Additionally no need to configure the parameter Row.processConfiguration.

[Former Member · Accepted solution]

Hi friend,

Still have the same result after I fixed the name correct end.Separator, look:

Am I puting the structure correct in txt file?

Input

Aaa,70,Bbc

Fff,80,Hhh

Sss,90,Nnn

In output file I can see only first line.

Look my Message Mapping, is it correct?

[Former Member · Accepted solution]

Hi Fabiano,

    The issue raised is for the output file but you have shared the screenshot of the sender content conversion.

    Can you please share the receiver content conversion that you are having issues.

- Muru

[former_member190293 · Accepted solution]

Hi Fabiano!

Just to be sure: your parameter must look like Row.endSeparator='nl', not endSeparation or end.Separator.

And couldn't you explain what is the mean of mapping message to itself without any change?

Regards, Evgeniy.

[former_member194786 · Accepted solution]

Hi Fabiano,

I noticed that the node Record is not mapped. Can you map that as well and see what is the output you see in mapping tab?

Regards,

Sanjeev

[former_member186851 · Accepted solution]

Check the eve suggestion.its Row.endSeparator.

Try and let us see

[Former Member · Accepted solution]

Hi Evgeniy,

Now I put Row.endSeparator, but still I have the same problem.

I want just pick up a file txt and from serverA and send to another serverB, I did it, but the information inside of file source is not same of file receiver.

I did this mapping because is necessary , right?

Thanks.

[Former Member · Accepted solution]

Hi Muru,

I didn´t content conversion to receiver, Is it necessary as well?

I need put the same parameters?

Thanks

[manoj_khavatkopp · Accepted solution]

So if u just want to send file as it is to target then u don't need any content conversion neither ESR objects ,just create config to pick and drop the file

[former_member186851 · Accepted solution]

Can you post the XML after FCC.

[former_member190293 · Accepted solution]

Hi Fabiano!

As Manoj has already mentioned, you don't need any ESR objects for simple point-to-point file transfer.

Just create ICo with dummy sender and receiver interfaces/namespaces.

Regards, Evgeniy.

[Former Member · Accepted solution]

Thanks friend, it´s ok now!!!!!

Scenario Complete with Succesfull.

[Former Member]

Hi Fabiano,

          Please refer below URL for more information on the content conversion;

XI/PI: File Content Conversion for Complex Structures

XI/PI: File Content Conversion for Simple Structure

- Muru