on 07-15-2016 4:32 PM
We have recently implemented workflow for Emergency Access Management in GRC 10.1. We have a handful of controllers where the notification type did not get set to "Workflow" before an EAM session was created; therefore, a workflow was not initiated. Is there a way to manually initiate a workflow after the EAM session is complete?
Thanks,
Sarah
Hi Sarah.
Take a look at SAP Note "1934127 - GRC10 EAM: EAM recovery program to retrieve missing log and to generate the missing workflows". It's about program GRAC_EAM_LOG_SYNC_TIMEBASED, but it works only for ID Based FF.
Regards,
Marcelo Monsores
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.