No Storage Conditions Selected - Stability Study

[dunky]

Hi,

I'm trying to complete an Stability Study but when i'm trying to specify the Storage conditions, despite there are defined two the system shows me a pop-up whit the error message "No Storage Conditions Selected".

As you see at the image below, two Storage condictions exists:

Thanks in advance.

Regards,

OCS

[former_member185453 · Accepted solution]

Hi,

After the initial Test is successful and approved (RR-UD etc.), the next step is to specify the storage conditions to keep the physical samples in.

I think you need to first select the both available storage condition (to do so select it from left most side as mentioned in below fig), then click on "save and change the notification".

Regards

S Ahmed

[dunky · Accepted solution]

Ohhhhhh!!!! I don't understand why, if you need to specify the quantity...this little SAP things.

Thank you so much.