Process Control_'No Data found' for Business Rule

[plaban_sahoo6]

HI All,

- I have created a Data source, which is in Active status, which has only 1 field: Vendor Account group from main table LFA1. Adhoc query gives correct results

- Business rule has filtered the Vendor Account group to ZTNN. But Adhoc query grouping on Vendor account group shows ' No Data Found'

- Deficiency field defined, as below

- Grouping

- Adhoc query, showing ' No data found'

Regards

Plaban

[former_member317290]

Plaban,

I am having this exact same issue - did you ever figure out how to get this to work?

Thanks

[Former Member]

Hi Plaban,

As per the screen shot you have provided. It is a value check Business rule.

• Value Check Business Rules fetch the current value of ECC Table ( i.e. LFA1).

        The message is not an error. It means that the information for current time frame was not found            for  that connector.

• Go to respective ECC system and execute SE!6 for table LFA1. Filler the value with Filter value and Deficiency field mention in the Business rule. If you run the result ,you will get no entries.
• Here are few SCN links that might help you

        https://wiki.scn.sap.com/wiki/display/GRC/How+to+set+up+a+Configurable+Business+Rule

       Debugging Business Rule Ad-Hoc Query - Governance, Risk and Compliance - SCN Wiki    

Hope the above information will help you.

Regards,

Rishabh Sahu

[plaban_sahoo6]

Hi All,

Could some one suggest on this error.

Regards

Plaban