on 05-18-2016 12:04 PM
Hi experts,
Can you please let me know is there any setting exist for inspection lot, if an user will go to do the usage decision of an inspection lot without completing the results recording then system will not allow to do the UD and will show error message .
With Regards
Akash.
Hello Akash,
This can be done using the User status profile,this user status profile needs to be assigned to the inspection type.
I hope this helps you.Please confirm if the issue is resolved,
.
Regards,
Chitrakshi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks Sarfaraz,
This link is very helpful.
With Regards
Akash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please go through this document.
Set up of a user profile to avoid the UD prior to RR - Product Lifecycle Management - SCN Wiki
Regards
S Ahmed
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Akash,
I am not aware of any such standard setup, which will block UD form being processed, in case RR is not done. You can try fixing this requirement done by checking the below two exits with ABAP team -
QEVA0006 Entry to usage decision transactions
QEVA0010 UD: Usage decision check
Thanks,
Arijit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.