Connection between SAP and RFUI

[former_member534593]

Dear All,

Please can you provide inputs how to connect your EWM  with HTTS devices, please let me know the pre-requeste for the same.

Do provide the configuration documents for the same.

thank you in advance.

Regards,

Richard

[parsa_trivedi]

For navigation into SAP ECC using the NWBC or a browser stand-alone, the HTTP destinations have to be created in transaction SM59 (Configuration of RFC Connections) in addition to the RFC connection that is already maintained in the data base view.

It is suggested to have the suffix _HTTP for the Destinations for a common HTTP connection. Similarly a secure HTTPS connection has to have the suffix _HTTPS.

Example

A data set in this table might look like this:

LOGSYS  EWM_SYSTEM

SYSTEM_ALIAS  SAP_EWM

DEST_RFC  EWMCLNT001

The HTTP connections may be maintained as follows:

Common HTTP connection  EWMCLNT001_HTTP

Secure HTTPS connection  EWMCLNT001_HTTPS

Regards,

Trivedi

(Pls award points if it was helpful)

[worldwidewebbd]

Hello Richard,

You use ITS inside SAP EWM and setup the services in SICF and then create a new internet service in SE80 and in that you assign all of the HTML Web-templates for the SAP dynpro screens to.

There is an RF cookbook somewhere on the SAP site that details all of the steps for the RF processing. See link above, that's the one.

Good luck.

Best regards, David

[jobi_t]

https://websmp201.sap-ag.de/~sapidb/011000358700000050812012E.PDF

This will give you the details

Regards

Jobi