on 04-27-2007 5:35 AM
in one of the blogs of Walk through BPM
i have seen the creation of
1 DT
1 mT
1 abs Interface
2 MI (ob and ib)
MP
MIP(source interface as OB and target as ABS)
dont we need to creat an interface mapping b/w ABS abd IB
and ID it says we dont have to create receiver agreement because the target is
ABS
dont we need to create a receiver agreement b/w ABS and target
Hi,
we need to create the receiver agreement using inbound message interface and the target BS.Not the Abs to target.
Regards
Chilla
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
>>dont we need to creat an interface mapping b/w ABS abd IB
Not required, if the abstract and inbound interface are basd on same msg type.
>>dont we need to create a receiver agreement b/w ABS and target
You need to create a receiver agreement in this case. Receiver agreement is not needed only if you have the target as an abstract msg.
P.S: Try to give a meaning ful caption to your question and frame the question properly to get good replies.
Regards,
Jai Shanakr
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
In IP ceck the configuration check , so that you can have the result , if no erros found then refresh cache.because it indicates the 99 in sxi_cache.
see the below link to monitor BPM
monitoring BPm https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/docs/library/uuid/e7bc3a5a-0501-0010-1095-eb4...
Regards
Chilla
could any one reply for me
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
89 | |
10 | |
9 | |
9 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.