Unconstrained Planning

[sb_fernandes]

Hi Experts

I am using S&OP supply.I have the following issues.Need your expert opinion.

1.While doing Unconstrained planning it’s not considering the existing stock on Hand. Suppose at DC I have inventory of 100 qty .

If I get demand of 200.I should get the transportation receipt qty of 100 not 200.Now its generating 200 qty.

2. Issue in capacity planning. It’s not updating the Available Capacity, Capacity Consumption and utilization Percentage Keyfigure in planning view.

Thanks in Advance.

Regards

Roshan

[Former Member · Accepted solution]

Hi Roshan,

1) Can you check the configuration of stock on hand kf, if it is marked stored or has any calculation?

Make sure you are entering values in the current bucket.

2) Is available capacity time series dependent? If not, then mark it attribute as key figure to appear in excel view. However internally it will be considered for calculation of capacity usage. Check the same for capacity consumption rate. If required, re upload these MDTs.

Thanks,

Rohit

[sb_fernandes · Accepted solution]

Hi Rohit.

You are rite I entered my SOH quantity in other bucket.After entering in initial bucket.

I changed the resource master with Time series indicator.Now I am getting Available Capacity.

Thanks for your reply.

Regards

Roshan