Initial Load for AUFK for SAP to SAP

[manish_gupta32]

Hi All,

I did the initial load for AUFK, the load was successful but the data got transferred to client 800 which doesn't exist in Target, as the source client was 800.

How can I make sure that the data is transferred to the desired client in the Target system?

How can I map the source and target clients?

Regards,

Manish

[Former Member]

Hello Manish,

When you say the load was success, and data got Transferred to 800 client which is not existing in the target systems.. then what happen to data where did it go ... can you please check SM21 logs for work processes to see where exactly the WP was connected to taregt systems.

RFC connection would help to data transfer but i am not very sure for SAP to SAP replication if data transfer uses the where clause for client selection.

can you check if you have those tables in you target systems.

Regards

Amar.

[former_member252769]

Hi Manish,

For transferring data to target system into specific client - please mention desired client while target RFC destination creation.

For source - if you want to select data from specific client then mark checkbox "Read from Single Client" while creating configuration and specify desired client while source RFC destination creation.

Regards

BJ

[manish_gupta32]

Hi BJ,

Thanks for your reply. I already had the settings as specified by you.

I actually achieved my requirement using the Domain Rule Assignment in MWB.

Regards,

Manish