One message type to 3 receiver message types

[venkatagiri_gongadi]

Hi All,

I have a requirement as follows ,

I will get a request from source system and need to send it to 3 different systems in different format like IDoc ,File and RFC.

Can i use one message mapping by adding 3 message types in signature tab? like one MT at source side and 3 MT (IDoc ,File and RFC) at target side?If yes,will I get any issue while testing as there are more than hierarchy?

Cheers,

Giri

[former_member182412]

Hi Venkatagiri,

Is your PI system is single stack or dual stack, do you have IDOC_AAE adapter? if yes then you can use 1:N multi mapping as per these documents

http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/90dcc6f4-0829-2d10-b0b2-c892473f1...

Regards,

Praveen.

[iaki_vila]

Hi Venkatagiri,

I think your case is a typical example to use SAP NW BPM. Another simplest alternative is to do three scenarios inside the same SWC because the functionality is similar, and the sender system do the three calls.

Regards.