on 04-05-2016 11:20 AM
Hello Denis,
As suggested by our friend Saravanakumar
you can remove the defect recording indicator from the MIC (Master inspection characteristic) control indicators, then system will not populate any defect recording if you enter the incorrect results
but for that particular MIC it will show major defect in the inspection lot display..
hence you have make the UD Forcefully
@ Thanks Sarfaraz and Saravanakumar..
Regards,
Venkatesh..
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Venkatesh,
thanks for the feedback.
Well I got only quality characteristics (yes or no) without lower/upper limit.
May be the problem once again: when the result of the characteristic is negativ (no) --> no error code shal be used. Well I just wann deactivate this pop-up where i'll be ask for the entering of the code.
BR
DEnis
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
yes, please check the MIC's control indicator in which defect recording indicator is enabled then by default if observed values not lies between your spec. then system will direct you to update the defect code. please untick the defect recording your pop up for defect recording will not come
thanks
Hello Denis,
As we will maintain the lower / Upper limit in the MIC through QS21 transaction
as per the results if you enter the exact results between these ranges then system will take it as accept
if the results beyond the between ranges then it will show as a rejected
hence please remove the upper limit and try
Regards,
Venkatesh..
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.