SAP for Utilities Discussions
Connect with fellow SAP users to share best practices, troubleshoot challenges, and collaborate on building a sustainable energy future. Join the discussion.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Error in activation group for AMI capabilities

Former Member

‎03-24-2016 4:39 PM

0 Kudos

Hello experts,

I was trying to configure the activation group for AMI capabilities through SPRO.

I defined two groups - one for smart and one for non-smart. Further, I added the AMI capabilities under these groups. However, when I tried to save this config, an error message popped up saying - "Table TEAMI_CAPACTGRC is not part of the customizing object VC_AMI_CAPACTGRPC".

Moreover, the view "VC_AMI_CAPACTGRPC" doesn't even exist in the system.

Has anyone seen anything like this before? This is stopping us from doing the required configurations.

Regards,

Asif

3 REPLIES 3

william_eastman
Advisor
Advisor

‎03-24-2016 4:52 PM

0 Kudos

Asif:

KBA 2049098 gives the solution for this issue.

regards,

bill.

Former Member
In response to william_eastman

‎03-28-2016 2:51 PM

0 Kudos

Thanks for responding William.

I tried the resolution steps mentioned in there. Apparently, the notes 1749724, 1752890 and 1750592 appear with status "Cannot be implemented" in my system, perhaps they are already a part of EHP7.

The resolution also mentions the "to-dos" on what if these notes are already present. However, i am bit struggling the steps that have been mentioned in there. Except steps 1 to 3, I am unable to replicate the other steps into my system.


Below is the translated piece from Google translation:

1. Play the SAP Notes 1749724 , 1752890 and 1750592 a .
If already happened and the error persists :
2. Start transaction SOBJ by choosing ' Maintain ' .
3. Position the object
Property VC_AMI_CAPACTGRPC
type V
If not available positions the object :
Property V_TEAMI_CAPACTGR
type V
4. Select the object .
5. Choose the level ' BOM ' from .
6. Press the button ' Match m . Dict . ' .
7. Save .
If already happened and the error persists :
8. Start the transaction SE54 .
9. Call the view cluster VC_AMI_CAPACTGRP .
10. Select "Enable" ( The info message to the SAP namespace can be igoriert ) .

Would appreciate if you could help.

Regards,

Asif

mohit_gupta13
Participant

‎11-18-2019 6:26 AM

0 Kudos

Hello Asif,

Were you able to solve this issue? i am facing same issue and unable to follow all steps mentioned in KBA. Thanks in advance!!

Thanks,

Mohit Gupta