Product missing from Planning Book

[Former Member]

Hi All,

We have a situation where a product is present in APO (visible in table /sapapo/V_Matloc or via tcode /sapapo/MAT1) but it's not getting loaded in planning book. We tried to remove the inconsistency by /sapapo/OM17 (at the location level) , but it didn't find any error. Also we did the consistency check at the planning area level.

So is there a way where we can remove such inconsistencies from the system ?

[alok_jaiswal · Accepted solution]

Hi Satyabrata,

Planning book which you are trying to use is DP or SNP Planning Book? For DP - can you check if CVCs are present for product in MC62 transaction.

Regards,

Alok

[Former Member · Accepted solution]

Hi Both,

I found out root cause for this issue. It was due to the value maintained at the SDP relevance field. Now its working fine. Thanks for the support.

Thanks,

Satya

[ruchi_das2]

Hi,

Please check if the location-product is assigned to a model and planning version in /SAPAPO/MAT1,

Regards

AK

[former_member225716]

Hello Satyabrata,

Could you please check whether correct planning version is maintained for missing product?

Also please run planning area level consistency and try to load selection in planning book.

regards,

Sachin

[Former Member]

Hi Sachin,

The planning version for the product is correctly maintained. Also we have ran consistency check at the planning area level , but still the issue is there. Also I can see that if we give * as location and try to load the product , its still not getting loaded.

[former_member225716]

Hello Satyabrata,

Please try to put *few digit of Product* in selection profile, may be some leading zero issue.

for example if product is 00001379990, put *137999* and try.

Regards,

Sachin