Successful Synchronous message is not displaying in PI SXMB_MONI

[former_member221434]

Dear Experts,

Only error messages are  displaying  in PI SXMB_MONI  But Successful synchronous messages are  not displaying  in PI SXMB_MONI,  While I have activated logging and logging_sync parameter in SXMB_ADM .

Regards ,

Pradeep

[sntamilselvan · Accepted solution]

Hi Pradeep,

How you confirm the messages are successful ? did it reach receiver system ?  if it is reaching there then it should be visible in MONI. Please check the details you have entered in the filter screen.

[former_member221434 · Accepted solution]

Hi Tamil ,

Successful messages are  receiving by receiver system and i have select all message in sxmb_moni filter .

Regards,

Pradeep

[former_member186851 · Accepted solution]

Pradeep,

This is strange.

Logging in SXMB_ADM should be enough.

Pradeep make sure any jobs are archiving or deleting the successful messages.

[iaki_vila · Accepted solution]

Hi Rahuraman,

You are right, if TRACE_LEVEL is no set to 0.

About Raghuraman idea, check also the parameters:

Regards.

[former_member186851 · Accepted solution]

Ya Inaki..lets c.hope it will work.

[former_member221434 · Accepted solution]

Hi Rahuraman ,Inaki Vila ,

I have set all parameter in SXMB_ADM  as suggested   above ,But still i am not getting successful message in SXMB_MONI .

Regards ,

Pradeep

[former_member186851 · Accepted solution]

Hello Pradeep,

1. No Jobs to delete/archive messages.

2.SXMB_ADM parameters are set.

3.Filter criteria is good.

Then it should work.

Can you throw some on light which scenarios are not getting updated.

[former_member221434 · Accepted solution]

Hi Raghuraman ,

May i know which jobs are responsible for it and where i should check .

Regards ,

Pradeep

[former_member186851 · Accepted solution]

Pradeep,

Below link will give you an idead

http://scn.sap.com/community/pi-and-soa-middleware/blog/2010/04/22/archiving-deletion-of-messages-in...

which scenarios are not getting updated?

[former_member221434 · Accepted solution]

Hi Raghuraman ,

Scenario name :

Soap to Proxy, and Proxy to Soap

[former_member182412 · Accepted solution]

did you canfigure classic or ICO if it is ICO it will only appear in adapter engine, if it is classic can you show the screen shot of sxmb_adm parameter configuration may be something wrong in there

[former_member221434 · Accepted solution]

Hi Praveen ,

I have configured classic scenario .

Please find below attached  screenshot .

[former_member182412 · Accepted solution]

Hi Pradeep,

Your sub parameters are wrong either remove them or configure possible values for specific pipeline steps. These are the possible values.

But you configured wrong, remove the sub parameters and test the scenario.

Regards,

Praveen.

[former_member221434 · Accepted solution]

Hi Praveen ,

Now It is working fine .

Thank u .

Regards,

Pradeep

[former_member186851 · Accepted solution]

Glad to Hear Pradeep.

And @ Praveen..Good one..Didn't think of sub-parameters.

[iaki_vila]

Hi Pradeep,

Have you selected all the parameters pointed by Michal in his blog ?

Regards

[former_member186851]

Hello Pradeep,

In the Intial message filter screen,Did you select all messages instead of error ones?