Change history inspection result

[maarten_muetgeert2]

I've a question about the change history of an inspection result. The result is recorded in two steps. A first person enters the result. And the second person closed the result. When closing the result I don't see anything on the change history. It looks liks this only applies to changes made to the actual result. Is it possible to see who entered the result and who validated the result?

Thanks.

[former_member198406 · Accepted solution]

Hi,

if you use global digital signature or no digital signature, you will not get change log in the given scenario.

it works as follows.

User 1 enters the result the characteristics status is 2 if valuated then 3.

User 2 Close the results the status become 5 (till this step no change log)

After this if someone again open the characteristics then system will create a change log that status was made 5 to 2. and after doing this if someone change the result after opening the closed characteristics, then only the change log can be seen.

Now, if you use dual digital signature (signature with signature strategy), you can get desired results.

refer the document.

DSAL is the transaction where you can get the log of who did result recording and who did validation.

Regards,

Dipeshkumar Bhavsar

[former_member218067]

How validation is carried out in system? do you use digital signature?