cancel
Showing results for 
Search instead for 
Did you mean: 

Cycle Counting - Transfer order

former_member272866
Participant
0 Kudos

Hello,

Is there a way to use cycle counting without closing all the open TO? I need to find a way to process cycle counts with open transfer orders.

Thank you?

Accepted Solutions (1)

Accepted Solutions (1)

former_member272866
Participant
0 Kudos

Besides that scheme has anyone got another idea?

Thank you

Former Member
0 Kudos

Hi

As mentioned, Dynamic Cycle Counting is the only way to carry out PI activities whilst open TO exist.

Cheers

A

former_member272866
Participant
0 Kudos

Yes,thank you,but using DCC what is the entire process/flow?

Because I am new using it.

Thank you,

Former Member
0 Kudos

https://help.sap.com/saphelp_erp60_sp/helpdata/en/69/80b6535fe6b74ce10000000a174cb4/content.htm

https://help.sap.com/saphelp_erp60_sp/helpdata/en/96/80b6535fe6b74ce10000000a174cb4/content.htmHi

The DCC process is exactly the same as with CC in that:

  1. Create a PI document via txn LX26.
  2. Enter the count
  3. Clear Differences

Please see the attached links for SAP text and DCC flow chart that shows which route the system takes for steps 2&3 depending on whether or not there are open TO's.

Cheers

A

Former Member
0 Kudos

Hi

Another advantage of DCC is that it allows the end user to create a PI doc via the RF scanner if they were to notice any ad hoc anomalies.

Cheers

A

former_member272866
Participant
0 Kudos

Thank you very much for your support!

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi.

Did you ask this earlier and then delete ??

Cheers

A

former_member272866
Participant
0 Kudos

It was removed by the processor.

Former Member
0 Kudos

Former Member
0 Kudos

Hi

I agree with Manish, DCC is the way to achieve this

Cheers

A

MANIS
Active Contributor
0 Kudos

Did you had a look on standard SAP Dynamic cycle count process

http://help.sap.com/saphelp_erp60_sp/helpdata/en/69/80b6535fe6b74ce10000000a174cb4/content.htm

former_member272866
Participant
0 Kudos

So basically in the end I have to confirm the TO,right? I cannot do it with them open?

Former Member
0 Kudos

Hi

No that's the beauty of DCC. You can carry out the inventory check without closing the TO's first. If however a difference is detected, the system will not close off the PI doc and when the TO's have been naturally confirmed as part of the day to day operations, the bin will be blocked and a recount initiated. It is only then when the recount process has been completed, that the bin is again unblocked.

Cheers

A