on 01-02-2016 7:44 PM
Hello Experts,
I have created ID in ECC and it gives the message successfully distributed to WMS.
But when i check in EWM system i didn't find any document.
Also i checked both smq1 and smq2 but didn't get any queue.
When i checked SLG1 i found below entries :
Please check if anybody have came across this issue .
Regards,
Hi,
ok, to properly check you should use the following sequence:
you have an inbound delivery in ERP, but no inbound delivery in EWM.
- check the inbound delivery notification
- check the EWM inbound queue
- check the ERP outbound queue.
- check if your distribution model is targeting the correct logical system (but then nothing ever can have arrived, so it should be one time problem).
Brgds
Juergen
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi sunil,
Check your queue in SMQ2 of ECC.may be distribution model is not working..
C K REDDY
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi sunil,
In addition to above reply...check queue in the ECC outbound queues with SMQ1.
There , observe the RFC destination is correct ,or, not...
If it not correct, use transcation BDLS to correct RFC destination in the tabe CRMRFCPAR.
But, you can check with your BASIS before using BDLS.
C K REDDY
Hi Sunil,
You can check once in ECC inbound que you will be find a que strucked.
Regards.
VIJAY
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
9 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.