on 12-22-2015 10:24 PM
Hi all,
What is the setting that makes a PM work order to have a inspection lot associated or linked to it?
here in our plant we get inspection lots created by IP30 and we noticed these inspection lots have a work order
I just want to know what config setting make this possible
thanks
neo
Hello Neo,
These are the SPRO settings, which you must already have had.
1. First we configure Inspection type for Plant Maintenance (usually 14) in this SPRO path.
2. Then we assign this inspection type to PM Order type here
like this.
For inspection lot to trigger while Order Release, you should maintain Inspection point in the Tasklist (IA05/06)
This value (300) was configured previously here.
Then coming to the mention of IP30 in your query
It is not Inspection lot which is created by IP30, This tcode is for scheduling Maintenance plans having the above said tasklists, to trigger Maintenance Orders in Release status. While doing so, due to the above mentioned configuration if the Order type matches, every Order geneated through IP30 would create an Inspection lot along with it. For such Orders, you will find a status ILAS after status REL.
Hope this helps
KJogeswaraRao
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi find the below link could help you ..
http://www.erpgreat.com/quality/sap-qm-module-configuration.htm
-Linganna
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.