Synchronous message- response payload

[former_member188791]

Hi Group,

I am using IDOC to SOAP synch scenario using Asy/Syn bridge, in RWB I am not able to see my request and response payloads, it is showing only target payload which sent to webservice, I already set XPI Service: Messaging System to false,but still I am not getting payload , I am using PO7.4 single stack, could you please suggest.

[Harish · Accepted solution]

Hi Rajiv,

Please check if the below properties are set (it is to see the source payload)

We have to set the below property to see both sender and receiver payload in message monitoring.

MS=3 & AM=3, this will enable to have receiver payload as well.

Please refer the below blog as well