on 11-28-2015 10:59 AM
Hi,
I need a small information.If i run the FBL1N, Report At header level, Vendor name is appearing.
While creating Up to 40 Characters only it will allow at T-code xk03.
In Data base level LFA1-NAME1 occupy 35 Characters only.
In ADRC-NAME1 Occupy 40 Characters only.
In FBL1n is there any chance to get name form ADRC table.
1. Append Structures RFPOS/RFPOSX with an additional field
2. In BTE 00001650 fill field with value from ADRC
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi, thanks For your reply. Not working, I did changes what u suggested.
Please have a look on below attached image. If i change it to 40 it was accepted.
Then i close the tcode again i open the FBL1N I execute the vendor code. Still it is taking 35 characters only.
Even i close my server too. But not working. Can u plz check it.. take 40 characters vendor and test it.
Hi NewB,
Like Michael told,
1. Append Structures RFPOS/RFPOSX with an additional field (lets say NAME1 - Vendor name in your case).
By doing this NAME1 field is made available in layout of FBL1n, FBL3n or FBL5n, reports.
2. In BTE 00001650 fill field with value from ADRC
BTE stands for business transaction event. By default Event "00001650" is assigned to a standard function module.
3. You need to copy this FM to a Z-FM and and assign it to event "00001650" (change the earlier assignment with standard FM).
4. In this Z-FM you can map the ADRC-NAME1 to the RFPOS-NAME1 and RFPOSX-NAME1 = 'X'.
Go to layout in FBL1n, FBL3n or FBL5n, Name1 field will be populated.
Let me know if you are still facing the issue.
Thanks,
NG
User | Count |
---|---|
89 | |
7 | |
6 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.