RSMIPROACT not sending PR info to SNC

[Former Member]

Hello all We are using DR process in SNC and thus want to use RSMIPROACT report to send Preq from ECC to SNC. I have set up Source list, PIR etc.and created Preq in ECC still Preq info is not seen on DR monitor. Although Idoc PROACT created carries Preq Qty and date and also PAN XML carries information. I also activated Time series type DFC01 & SMI02 in SNC system Please help if I am missing any thing here? Thnx Vipin

[Former Member · Accepted solution]

Hello V_SAP,

Can you share the RSMIPROACT selection screen's screen shot?

It will be much more easier to guide you to correct selection parameters.

Regards,

Selim Batur

[Former Member · Accepted solution]

Hi Selim

Please find herewith screen shot

Thnx

Vipin

[Former Member · Accepted solution]

Hi Vipin,

Your selections seems like correct. What do you see once you execute in simulation mode?

Meanwhile, did you check relevant combination's PR information via MD04?

Regards,

Selim Batur

[Former Member · Accepted solution]

   Hi Selim

   The PR data in transmitted in PROACT Idoc & PAN XML successfully. The issue is on OFM monitor PR Qty not appearing in SNC

Pl find below simulation screen results after running report in ECC

  Thnx

   Vipin

[Former Member · Accepted solution]

Hi Vipin,

Look at BP you are using, whether it is same as Vendor used in RSMIPROACT?

It would be Basic, which we would miss sometimes...

Let me know if you need any help.

Regards,

Guru

[former_member614172 · Accepted solution]

Hi Guru,

Could you please provide your contact email address ?

Thanks,

Kathir