on 11-03-2015 6:04 PM
Hi all,
I have configured a routing rule through a procedure call in BRF+ and the decision table works perfectly when simualation is done at the BRF+ level.
I have also configured this in my MSMP workflow. But for somereason the workflow does not pick up my routing rule and is not routing appropriately.
Could someone please help me on what and where I should go and check?
Should I re-activate BRF+ after In transport it to a different test client?
Thanks
Lakshmi
Dear Priya,
did you activate the MSMP workflow? This is a common issue...
Also please share the Audit Log of a workflow that has passed the stage.
Regards,
Alessandro
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Yes Allesandro. I did activate MSMP after importing to different client. I am also having an issue that I am still waiitng for suggestions on topic ""
Actually my audit log shows that it never even considers the routing rule ID. It doe snot even gets the result of risk analysis and figures out SOD issues exist or not. It completely skips it and goes to Security stage as if no SOD issue exists.
I have configured my decision table for routing rule through procedure call. Coul you please also comment on that discussion if there is anything wrong the way decision table is done?
Thanks
Lakshmi
Hello Priya,
Check the Audit Log and SLG1 log.
This might give you some clue why it does not get routed.
Thanks,
Mamoon
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.