Infopackage not completed but its successor jobs got triggered......

[Former Member]

Hi Guys,

could you please suggest me how this happen...

Infopackage not completed but its successor jobs got triggered

[Former Member]

For this issue we have raised OSS message to SAP.

they replied that we have to see Note-2123865.

Regards,

Atul.

[Former Member]

Timing of infopackage finish job and successor job are just 1.5 sec different.

DTP got started 1.5 sec before and missed some data in cube.

[former_member183519]

Hello Atul,

For this type of problems.. right click on process chain step which is in yellow-> go to Messages.->

go to chain tab-> check for End-?target event and with parameters.

If this two fields are blank, for along time and next step(jobs) still triggered, then you need to resolve this using 'RSPC_PROCESS_FINISH' program..

Run program RSPC_PROCESS_FINISH ->

Fill above details using Lookup in RSPCPROCESSLOG table..

Regards,

Hitesh

[Former Member]

HI Atul,

As said by Raman KV.. Please try to to follow the step.

By using skip option we can continue next process steps.

please check your info pack monitor, whether it was ran by manual or not.

if it was ran by manual then you can see the user who ran it at header tab of info pack monitor area.

If the above doesn't solve your problem.

If you want to run the  skipped process(infopackage).

Please try to delete the Previous Load run logs for that chain and Repeat the process.

Use this programe to delete the logs SE38->RSPC_LOG_DELETE

After doing the above if the same issue arises. need to investigate further.

Regards

Vinod

[Former Member]

Hi Atul,

What i think is It should be some issue with the updation of tables which stores the status information of these loads.

Please confirm whether it is a one off thing or happening frequently. There is no way that this can happen regularly.

Also check whether the technical status of the load is green and just in the process chain display it is Yellow.

Regards

Vivek

[Former Member]

Can you please tell which TABLE stores the status of loads..

[RamanKorrapati]

Hi,

By using skip option we can continue next process steps.

please check your info pack monitor, whether it was ran by manual or not.

if it was ran by manual then you can see the user who ran it at header tab of info pack monitor area.

thanks

[yashcp]

Hi Atul,

Did you check some body might have have pushed the chain ahead through RSPC_PROCESS_FINISH?? This might have happened because of this