BubbleException in Proxy Recevier

[manikandan_shanmugam3]

Hi All,

I am using common proxy receiver channel (SOAP XI) and message is failing for one particular interface only but other interface works fine.

I have cross checked the proxy structure between PI and ECC and it is same.

Regards,

Mani

[Former Member]

Hello Mani,

I have seen this error many times in my previous project. In our case, it has nothing to do with PI interface setup.

these error comes up when ECC is not able to get a response back from PI over a connection. Ask your basis team to check it.

Regards,

Gavaksh

[suman_saha]

Hi Mani,

Check whether you have selected XI3.0 protocol.

Regards,

Suman

[manikandan_shanmugam3]

Hi Suman,

Yes, Proxy Common channel is not throwing error for other interface.

Regards,

Mani

[former_member186851]

Hello Mani,

Then check the service interface type used .Is it same like others?

[maheswarareddykonda]

try just change from XI 3.0 to Soap 1.1 and save activate.

after that again change that Soap 1.1 to XI3.0

also Check this https://scn.sap.com/thread/3184803

[former_member186851]

Hello Mani,

You have module beans for this particular scenario or any specific setting compared to other interfaces?

[manikandan_shanmugam3]

Hi Raghuraman,

There is no specific setting. It is just proxy trigger from PO System.

Regards,

Mani

[former_member186851]

check the protocol once Mani if your not reusing the channel.