on 10-26-2015 5:46 PM
Hi,
I enhanced a data source with 2 fields, wrote customer exit and checked the data in RSA3. I see the enhanced fields getting populated.
But the problem, after replicating this datasource in BW and running infopackage, i see 0 records.
i have attached rsa3 output, job overview. (enhance fields "characteristic name" and "value desc" in RSA 3 snapshot)
I went through couple of discussion here in forum but could not find solution.
Am I missing something.
Thanks,
Vinay
Hi Everyone,
Thank's everyone for the support. I had done all the checks suggested by you all before. (Info package filters, idocs, everything).
Issue was with authorization, later we added SAP_ALL & SAP_NEW.
So we were able to successfully pull the data to BW.
Regards,
Vinay
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vinay,
it seams that you have selection in the info package. Remove it and try again...
BR,Todor
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vinay,
What kind of info pack you ran at bw side?
is it full load or delta load?
at RSA3 will give the full load output and you might be triggered delta info pack.
if its delta info pack then please check records count at RSA7 and after that you run the info pack if records exist at RSA7 against your data source.
Whats your data source name?
before enhancement have you take care all previous delta data?
if not then delta might be corrupted due to structural changes.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Did you look the log of request in PSA ?
Thiago.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vinay,
check if the info package has any filters in data selections tab. And also, is this the first time you are extracting data from this data source to BW ? are you able to pull data from source system to BW for other data sources?
check if you source system has different clients? some may keep data in one client and another client just for development. please check .
User | Count |
---|---|
84 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.