There is no operation number selection in Capacity leveling

[Former Member]

Hello, experts.

Question is related to PS networks by operation capacity leveling, I found, there is no operation number selection in Capacity leveling.

We have the neccesity to do leveling for networks by operations. There is sort rule for operations by one parameter. This parameter is calculated during project scheduling. We should do capacity leveling for first scheduled by parameter operation, then do project rescheduling for parameter recalculating. Then do operations resorting and do capacity leveling for next operation and so on. We have EHP7 installed in our system. This is story.

Network number and operation number of network must be selected in leveling. I've created multi-set ZSPPNW4. I use few basic sets for operation number just in case. Then i've created selection profile on base of multi-set. Then i've created overall profile on base of selection profile.

Then i run transaction CM25, select created on last step overall profile. I've got in selection screen order number field only.

Do you know why no operation number field in selection screen? What i do wrong?

[MTerence]

Hi Sergy,

Have you tried by using standard profile SAPCRPG003 and checked whether this is displayed ? If not check with this profile.

Regards

Terence

[Former Member]

Hi, Terence.

I've tested overall profile SAPCRPG003, no way, I've qot order and planed order numbers in selection screen. I added to the profile, created on base of this profile, operation number and did not get this field in selection screen. I forgot to write we use graphical planning board.

[MTerence]

Hi Sergy,

Can you please share the screenshot where you are expecting the operation / Activity number?

Regards

Terence

[Former Member]

[MTerence]

Hi Sergy,

Refer whether this thread is helpful. Also it will be better if you get in touch with PP consultant

Custom Column(Field) addition in CM25 Using Use... | SCN

Regards

Terence