on 10-19-2015 2:05 PM
Dear QM Gurus,
I have done a GR for 10.
While doing UD, I manualy posted 8 pc to unrestricted and put 2 in blocked stock.
What is the process to follow when I decide to move the Blocked stock to either Urestrcted use or Qhold.
Kindly advice
Thanks
Mudassar
Hi Mudassar,
You can use Tcode MB1B with mvt. type 349, this would create an Inspection lot (lot origin 08)
Note: Insp. Type 08 should be activated in Material Master.
Process the Insp. lot 08 and do RR and UD (here you may decide stock posting.
OR
Tcode MB1B with mvt. Type 343, this would not create any Insp. lot and stock will be posted to Unrestricted.
Hope this will help you.
Regards
S Ahmed
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Sarfraz,
Movement type 343 is working.
But Im getting below error when using 349 (since I might have to create an Insp lot again)
Change the inspection stock of material 20144641 in QM only
Message no. QA495
Diagnosis
You want to make a stock posting to/from the inspection stock. This is not allowed for material 20144641 because the quality inspection control has been activated by QM.
The following cases can occur:
System Response
You cannot carry out the stock posting.
Procedure
Check both the QM inspection setup data and the movement type for material 20144641 in the quality management view of the material master.
Exception:
Please suggest further...
Thanks all.
Issue solved.
Closing thread and awarded points
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Mudassar,
Q :What is the process to follow when I decide to move the Blocked stock to either Urestrcted use or Qhold ?
Ans : First of all it can be done with QM or without QM.
Without Qm :
Tr code MB1B and movement type - 343 for Transfer posting blocked stock to unrestricted-use stock .
Tr code MB1B and movement type -349 Transfer posting blocked stock to quality inspection stock 349
With QM ;
1) Activate Inspection type 08 ( 08 - Stock transfer inspection) in material master
2) Create a inspection plan with tr code QP01 ( usage -5 , status - 4 , and put the planner group )
3) in the material master QM tab , inspection set up tab , select the tick box as With task list.
4) When ever you will use the movement type 343 and 349 with Tr code MB1B , a inspection lot will be generated.
5) complete the Result recording and UD ( QA11) .
Thanks
Subhrant
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.