on 10-19-2015 8:07 AM
Hi all,
I have a porblem while run t-code RZ70 (Gateway Host: portal_host name, Gateway Service: sapgw00)
as follows:
"RFC data prepared
Used RFC destination: SLD_UC
RFC call failed: Error when opening an RFC connection (CPIC-CALL: 'ThSAPOCMINIT' : cmRc=2 thRc=67
I have done these steps:
1) Set SSO parameters in the backend ABAP system ECC EHP6 by the t-code RZ11
2) Add CA of EP into backend.
3) Create a "system" in EP and finished OK.
but show " Connection failed. Make sure user mapping is set correctly and all connection properties are correct. " while testing.
4) SLD Configuration
So, Can anyone tell me where the problem is taking place?
Thanks & Best Regards
M.H
Hi MH
1. Kindly review the SSO steps as mention in the SCN link
2.
"RFC data prepared
Used RFC destination: SLD_UC
RFC call failed: Error when opening an RFC connection (CPIC-CALL: 'ThSAPOCMINIT' : cmRc=2 thRc=67
For this you can refer the SAP KBA's
1727745 - RFC connection error while executing transaction RZ70
1731348 - RFC call failed: JCO.Server could not find server function 'SET_SLD_DATA'
Regards
SS
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello MH,
The error return codes are incomplete. I believe that "cmRc" would be 20, most likely, but there are different possibilities for "tcRc=67X".
Do you see the error (or a related error) at any "dev_rfc??" trace?
What about at the "dev_jrfc" traces at the SLD end?
Best regards,
Isaías
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
83 | |
24 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.