IDOC Trigger error

[Former Member]

Hi,

I am doing IDOC to File scenario using Java only stack. While triggring the IDOC I am getting an error as - IDOC was saved but cannot or should not be sent. What should I do?

Regards,

Himani

[Former Member · Accepted solution]

Hi,

Please check the followings :

1.go to WE20 : Partner Profile config : Outbound message parameter : give the Outbound message type name .

2.WE21 : check the Port configuration.

3 SM58 : Check the Error details and you can be able to find the exact cause.

[Former Member]

Hi All,

Thank you for the suggestions. Those were very useful. I have checked for both SM20, SM21 and SM58, but after checking in SM58 I am getting error as below:

what should I do ?

Regards,

Himani

[rasjoshi]

Hi Himani,

Please reimport your metadata in PI... RWB --> IDOC Monitoring --> Metadata Tab

BR,

Rashmi

[former_member186851]

Hello Himani,

Check the IDOC adapter configurations in the PI and check for the metdata in PI. After doing all the changes stop/start the channel.

[pvishnuvardan_reddy]

Hi Himani,

As suggested by Rashmi, pls navigate to NWA-->Adapter Engine-->IDOC monitoring-->Meta data tab

Delete the entry for the corresponding IDOC for which the issue is occurring.

And retrigger the IDOC and check the outcome.

[Bhargavakrishna]

Hi Himan,

This might be due to either the partner profile is not configured properly or your idoc has wrong structure.

--> Check the idoc control record  and verify Sender / receiver port, partner names, partner type are correctly maintained.

--> check if the idoc structure is changed recently and not updated.

Regards

Bhargava Krishna

[former_member186851]

Hello Himani,

check the partnerprofile/port and then the idoc structure.

[Former Member]

Hi Himani,

While transferring of IDoc, RFC ports might be closed. Check if the connection is working fine. Goto sm58. If you are not authorized ask help from your basis consultant. Also check what is the current status of your IDoc in we05

Regards,

Diptanshu Gupta

[pvishnuvardan_reddy]

Hi Himani,

Check the error in sm58, you can get to know the root cause for the failure.

Can you refer the below links and see if helps you.

https://scn.sap.com/thread/1892053