on 09-26-2015 1:23 PM
Hi All,
Could you please suggest me how to configure the below requirements:
We have variant based pricing and currently there is only one variant which is used for pricing in sales order. Say X
There is another Variant Y for the same material & Plan is to use this for pricing too.
Condition records of both variants are maintained in the same access sequence.
Presently the configuration is in place and both variants are appearing in the sales order.
Plan is to have only one pricing activated in the sales order( for which the condition record is maintained)
If both condition records are maintained, logic has to pick Y variant.
Your inputs will be appreciated.
Thanks
Anil
Hello Every one!
We have done the coding in the user exit, and now i can able to do the pricing based upon the grades.
We have set a validation check like Check if Variant X exists then pick the X if not the Y.
If both Variants X and Y exists then Pick only X.
by this way we achieved the above functionality.
Thanks
Anil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear All,
Is this possible by writing a requirement routine and assign to the condition type? or any other configuration needs to be done?
Please suggest.
Thank you
Anil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Anil,
If you have 2 different access maintained for Variant X and Variant Y in the same access sequence then change the no of access in access sequence by making Y 10 and X 20. If exclusive check box is checked system will not move to X and will exit after picking Y.
I'll not suggest writing any code if this can be handled via config.
Regards,
Chintan
Hello Chintan,
Thanks for your response!!
Currently we have Variant as common field in all the key combination for the access sequence ex: Country/Curr/Variant & Curr/Variant.
Variant will be applicable for all the available variants characteristics.
So what we thought is to write the required code in the user exit.
Will this be correct approach?
Please suggest if any.
Many thanks in Advance!!
Regards
Anil
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.