Application Development Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Showing results for 
Search instead for 
Did you mean: 

TRUST entry does not exist when Switch Digital content

0 Kudos

Dear all !

After run Report RTCCTOOL, I follow the recommend to Activate the

Digital content.. on my PRD but it has an error below

"TRUST entry does not exist"

#### Recommend From RTCCTOOL Report ####

4. [Note 69455 ] Switch on digital content verification

Description Switch on Digital content verification for

recommendations

of SAP Service prep. check (RTCCTOOL).

Implementation From the menu choose "Goto->Digital signatures" and

press "Activate".


Did you see it before ? I have read the infor in note 69455 but it's doesn't said why i met this error.


Best Regards.

Luan

1 ACCEPTED SOLUTION

hugo_amo
Employee
Employee
0 Kudos

Hi Luan,

This  question should have been created in a different forum as this has no relation to the database whatsoever, so you may want to move it to the correct forum or create a new thread and close this one. As you wish.

In any case, I would recommend you to follow the steps in SAP Note:

662340

662340 - SSF Encryption Using the SAPCryptolib

and

510007

510007 - Setting up SSL on Application Server ABAP

As this error usually comes up when there are missing profile parameters or perhaps a spelling mistake was made.

Hope this helps.

Best Regards,

Hugo

2 REPLIES 2

hugo_amo
Employee
Employee
0 Kudos

Hi Luan,

This  question should have been created in a different forum as this has no relation to the database whatsoever, so you may want to move it to the correct forum or create a new thread and close this one. As you wish.

In any case, I would recommend you to follow the steps in SAP Note:

662340

662340 - SSF Encryption Using the SAPCryptolib

and

510007

510007 - Setting up SSL on Application Server ABAP

As this error usually comes up when there are missing profile parameters or perhaps a spelling mistake was made.

Hope this helps.

Best Regards,

Hugo

0 Kudos

Thanks Hugo,

This is really helpfull.

Regards

Luan