Unable to Post /SAPTRX/BAPI_EH_POST

[arun_yesodharan]

Hi All,

   I am trying to activate the Procurement Visibility Process.The FM's are triggering at the time of vreation & change of POs.However the log in SLG1-ECC shows that the RFC is unable to post the  /SAPTRX/BAPI_EH_POST.

  Hence no events are generated in SAP EM. The major configurations are as follows:

Assignment of Event Manager to AOTs & ETs

System Failure

However RFC test is successful.

Mapping area assignment

Event Manager in EM

I tried to debug the BAPI_EH_POST , it is triggering  & has values as well but eventually does not post any events in EM & the log is generated in ECC as mentioned.

Kindly help.

[arun_yesodharan · Accepted solution]

Hi Everyone,

   I have wrongly assigned the ECC system as the EM logical system in the Define EM Configuration @ the EM System.

  Thanks for all the help.

[arun_yesodharan]

FYI : Recently I faced the same issue with another client , however this time at EM Side , Client & Logical System assignment was missing. Error message can be misleading at times. 🙂

[former_member190756]

Hi Arun,

please check ST22 for a dump in EM system.

Has the RFC User enough authorization to create EHs?

Best regards,

Steffen

[arun_yesodharan]

There were  Dumps in ST22 stating the FM: "/SAPTRX/BAPI_EH_GET_DATA" is not available. But when i check the same in EM system it is available.

Also the RFC USer is currently having all the authorization including:/SAPTRX/SAP_AS_ADMIN &/SAPTRX/SAP_EM_ADMIN.

[former_member190756]

This sounds strange.

FM: is not available would indicate that the wrong system was called.

Best regards,

Steffen

[Former Member]

Hi Arun,

In your EM manager screen shot, RFC is pointing to EC6CLNT120 box. IS this destination ECC or EM? If T81* is the EM system, then you should have T81CLNT120 as your destination in Event Manager.

Please check and let us know.

Thanks,

Vishnu

[arun_yesodharan]

I Vishnu,

  There are 2 Define EM Nodes. One in ECC & another in EM.

In ECC this is the config:

RFC is from ECC to EM System- Event Manager is SCEM

In EM System the config is:

The RFC is from EM to ECC System

Is this setting wrong??

[former_member190756]

Hi Arun,

you only need to make the settings in the ECC system.

In EM system you need to make the settings in /SAPTRX/TSC0AS back to the ECC system for acknowledgement and log transfer.

Best regards,

Steffen