on 08-21-2015 11:51 AM
Hello colleagues,
I've faced with the following problem. When I transport EUP configuration for templates to productive system I don't get any results.
BCset with EUP initial configuration was transported from dev to prod. Customizing was done and tranpsorted. I see that all customizing exists in prod, so prod is equal to dev (SPRO - ... - Maintain End User Personalization). However, my templates based on the same EUP Id differ.
Example:
As you can see in dev system some fields look different (non-editable, hidden, unnecessary), but in prod system all fields stay untouched.
I found note 2111894 and applied an SP stack, but it was in vain. Could anyone give me a hint why this happens?
My SPs level are the following:
COMPONENT | RELEASE | EXTRELEASE |
GRCFND_A | V1000 | 0020 |
PI_BASIS | 702 | 0017 |
SAP_ABA | 702 | 0017 |
SAP_BASIS | 702 | 0017 |
SAP_BW | 702 | 0017 |
ST-A/PI | 01Q_700 | 0000000002 |
ST-PI | 2008_1_700 0012 |
Regards,
Artem
Dear Artem,
Please do check out the below notes, they might be helpful to you.
1884227 - EUP fields along with their values do not transport completely
1558448 - Inconsistency in EUP settings of Access Request
Thanks,
Fazil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Fazil,
1884227 - EUP fields along with their values do not transport completely
This note helped me much! It was hard to find it on support.sap.com.
Regards,
Artem
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.