Negative Values in DP Interactive Charts

[former_member717176]

All, I am putting together a set of standard DP Charts in SDP94.

In one specific planning area some key figures are read as negative values in charts and are displayed as such.

The interactive planning table clearly has the values stored as positive values.

I have checked the obvious settings in Chart Customising but cannot see an obviously incorrect setting.

The problem exists for some temporary key figures and time series key figures.

Got any thoughts as to why my positive values are displayed as negative.

See attachment.

Message was edited by: Christopher Walker Please Note EHP1 and EHP2 on SCM 7 have been implemented.

[former_member717176 · Accepted solution]

Negative Values in chgarts have been resolved.

This is a key figure setting in the Interactive Planning Design Mode (key figure setting ) 'Invert Values in Chart!' !